Just got my Picade last week, and thanks to the video, assembly was pretty much on the nose.
Every single part was of easy assembly, and took about 3 hours from start to finish!
However, I'm having lots of issues trying to get it to work... And find little to no detailed instructions on how to properly setup the software.
I can't seem to make it work on the 8" standard screen from the kit, and can't use sound on it either. I do know that the board seems to be working, since I was able to use it connected to my hdmi tvs, with the arcade stick and buttons working on spot with retropie 3.5.
I did found the suggestions on the reviews to edit the config.txt, but not sure if I added the extra lines properly (I'm somewhat tech savvy, but definitely not used to using code).
In any case, it didn't work... And I can't figure out why. I'm pretty sure that it's not from the connections, as I followed your instructions on the nose, and double checked all the connections before inserting the last screws in the build.
Any light you can share would be greatly appreciated...
