Hi,
Having difficulties using the pHAT with my zero. Connecting up a 1-wire temperature probe directly to the Zero and i can figure out how to read it but when i try to plug it into the HAT it's not working. I know this would suggest a soldering issue but i'm not sure. When i try to read the probes 'number' i get a line of zeros when i should get something like this - 10-000802824e58
I'm using the +5v (the tutorial i'm reading says you should use 3V3) , GND and 1 of the 'Inputs'.
Am i right in using the 'input' as that from the probe or should i use one of the 5V Analog points? I find the labeling of terminals a bit confusing and not especially clear. I thought if i was just to refer to the GPIO pin i thought was connected to the probe it would work
Thanks
gbar