Hi there,
I want to use the Unicorn HAT (8x8) with a Pi0 (Raspberry Pi Zero).
Therefore I have a little wishlist for a new version of the Unicorn HAT to make it more compatible with the Pi0:
- Pls provide mounting holes in the middle of the right and left side fitting to the holes on the Pi0 so mounting to the Pi0 would be a piece of cake.
- Pls provide soldering pads for VCC, GND and DIN in the center of the PCB on the rear side. I'm to lazy to solder a 40pin header when I need only 3 pins. With this pads I could simply solder short leads to contact the Pi0 with the Unicorn HAT
I appreciate your efforts. XMas is coming fast!
Greetinx
/H.