What are the advantages of using 'flotilla-python'
That's neat device... not seen those. Adafruit make some great stuff, but it is expensive. You could do the same with an Arduino and an i2c LCD, or LCD shield (exactly the same display) for about...
View ArticleWhat are the advantages of using 'flotilla-python'
I completely agree. It's a straightforward task to hook up an Arduino and a breadboard and LCD display. I was thinking of ways to connect the Flotilla dock to a display.(I've just ordered some USB-B...
View ArticleHow about a lego layer for Pi Zero?
Hay Conner - would it be possible to produce a Lego layer for pi zero - to either replace the bottom layer or add an extra with longer screws.
View ArticlepHATdac + Pi Zero software?
We have success! Although I touched the USB cable and it rebooted and now won't connect to the network, so I'll re-do the SD Thanks guys!
View ArticlepHATdac + Pi Zero software?
OK, as soon as I reboot it no longer connect via ethernet :( Weird
View ArticleWhat are the advantages of using 'flotilla-python'
hum, the firmware space on the dock is limited, not sure using it up to drive a display type module would be the best use of it... I guess it depends what you see flotilla as. anyhow, the dock...
View ArticlepHATdac + Pi Zero software?
Right, seems my USB ethernet is a bit flaky, so it's all working now, just can't get wifi working with the official raspberry pi usb wifi. does it need something loading?
View ArticleWhen Pressed, Pibrella Button Reboots Pi
Hey there, I recently purchased a pibrella board (Pibrella Rev 3) for use with my raspberry pi. I've attached the pibrella board to my pi. However, when I press the red button on my pibrella, the pi...
View ArticleWhen Pressed, Pibrella Button Reboots Pi
It's been a while since I've seen this one, but I'm going to bet it's the metal contacts of the button, or something similar, shorting out on the HDMI connector. Stick something insulating between...
View ArticleClik here to view.
When Pressed, Pibrella Button Reboots Pi
ameh: I thought it was a pin issue, and tried different pins, but that didn't work either - plugging the board on the remaining pins resulted in the pi not starting up at all. err, what do you mean by...
View ArticlepHATdac + Pi Zero software?
how are you adding the WiFi details in to Volumio? I've had the best results from editing the /etc/network/interfaces file and adding the wireless key and SSID in to there. can you see your wireless...
View ArticlepHATdac + Pi Zero software?
Yeah, added the details there, then rebooted with the wifi plugged in - think I'm gonna have to get myself a USB had as this is getting a bit silly :)
View ArticleWhat are the advantages of using 'flotilla-python'
Thanks for the advice. It's not just an LCD as an output I'm curious about. :-) I've got a box full of bits from my Arduino tinkering that may be able to be used as inputs too. Stuff like a light...
View ArticlePicade Board Firmware Update
Herald the new Picade 2.x firmware, with dynamic rebinding and keyboard/gamepad support: http://forums.pimoroni.com/t/new-2-x-configurable-keyboard-gamepad-firmware/1881
View ArticleEpisode 026 - Proto Mojo
We've been busy little beavers developing new and shiny, and making sure the existing-and-also-shiny isn't left by the wayside. Jon demos "Mote", a new, smart, USB serial driver board for strips of...
View ArticleWhat are the advantages of using 'flotilla-python'
You'll need an Arduino to act as the brains, and translate your sensors into something that Flotilla can understand. But what you propose certainly isn't impossible! Your best bet for a single value...
View Article